Bakun

Buscar este blog

STEP THE STENCIL PRINTMAKING PROCESS

el agosto 31, 2018

Obtener enlace
Facebook
X
Pinterest
Correo electrónico
Otras aplicaciones

Obtener enlace
Facebook
X
Pinterest
Correo electrónico
Otras aplicaciones

Comentarios

Publicar un comentario

Entradas populares

PERSONAL PORTFOLIO

STEPS 1. Preparation of the final art (Design and assembly) 2. Tensioning the mesh in the frame 3. Degreasing and drying mesh (Use of soap) 4. Emulsion preparation + sensitizer (photosensitive material) 5. Emulsification and drying of the mesh 6. Process of relieved - 5 minutes to exposure of light. (Appropriate weight to obtain a good development + acetate design). 7. Washing the mesh to clean areas that have not received light. 8. Process of pre-printing, preparation of inks (orange and blue), mask the frame to avoid the crossing of ink in undesirable places. 9. Put ink to start the printing process, it is necessary to take into account the registration of the two colors since it is important that the printing is aligned correctly. 10. We use the racle so that the ink covers the places where it is not emulsified, at an angle of 45 we pass the racla with some pressure (Pass the racle twice) 11. We obtain the proof printing to verify if all the proced

INFOGRAPHIC DESIGN

Infographic design of How to make a book process Printing technique: screen printing

PLAYING CARDS DESIGN

STEPS 1. We prepare the sketches for later vectorization. 2. For this project we will use textile ink, screen , stencil art adhesive, support, paper tape, cutter. 3. We started cutting the arts to get a stencil. 4. Stick the adhesive on the outside and place the mesh over the support (Make registration so that the mesh aligns with the support) 5. We deposit the ink inside the screen. 6. We do not completely set the mesh on the stand, we pass with the squeegue on the screen to load ink. (One uniform layer) 7. Now if we settle completely and re-pass the squeegue this time with a certain pressure and at an angle of 45 degrees. (We pass twice, it must be a uniform pressure) 8. Carefully remove the screen to avoid staining somewhere unwanted and ready we will have the impression.

Con la tecnología de Blogger