STEPS
1. Preparation of the
final art (Design and assembly)
2. Tensioning the mesh
in the frame
3. Degreasing and
drying mesh (Use of soap)
4. Emulsion preparation
+ sensitizer (photosensitive material)
5. Emulsification and
drying of the mesh
6. Process of relieved
- 5 minutes to exposure of light. (Appropriate weight to obtain a good
development + acetate design).
7. Washing the mesh to
clean areas that have not received light.
8. Process of
pre-printing, preparation of inks (orange and blue), mask the frame to avoid
the crossing of ink in undesirable places.
9. Put ink to start the printing process, it
is necessary to take into account the registration of the two colors since it
is important that the printing is aligned correctly.
10. We use the racle so that the ink covers
the places where it is not emulsified, at an angle of 45 we pass the racla with
some pressure (Pass the racle twice)
11. We obtain the proof
printing to verify if all the procedures are adequate and then print the final
art
Comentarios
Publicar un comentario